The best engineers and chemists from major chassis manufacturers spend years developing the layout, design and coordination of their products. This should be important to you when choosing your spare parts!

Only if products pass the manufacturers' extreme stress tests can they be installed at the factory. This is not the case with many aftermarket solutions. Our products undergo and pass these endurance tests day after day!

The design of a product is not just about the superficial appearance. It is about the inner values. Only the original material pairings, the original technical layout and the many development steps behind it guarantee that the product works and is safe!

Large chassis manufacturers test their products on test benches, in special test facilities and in the vehicle. These tests guarantee you reliable function and durability. Only properly tested is really good!

When it comes to products in the chassis sector, every hundredth of a millimeter counts. Excessive forces or the use of incorrect tools can cause lasting damage to the products or even lead to total failure. Only if the product fits well will it perform well!